Creek Audio EVOLUTION 50CD Kullanım Kılavuzu - Sayfa 4

CD Çalar Creek Audio EVOLUTION 50CD için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Creek Audio EVOLUTION 50CD 13 sayfaları. Dac / cd player
Ayrıca Creek Audio EVOLUTION 50CD için: Kullanım Kılavuzu (13 sayfalar)

Sayfayı Yazdır

GETTING STARTED

The EVOLUTION 50CD is not just a CD Player; it is primarily a Digital to Analogue Convert-

er and Pre-amplifier, fitted with a Slot Drive CD transport as one of its digital sources. The

DAC has 2x SPDIF and 2x TOSLINK digital inputs capable of reading digital signals up to

24 bit 192 kHz high-resolution. The USB input is capable of playing 24 bit 96 kHz files from

either a PC or MAC computer, without additional software drivers needing to be installed.

Connect your EVOLUTION 50CD to a suitable audio amplifier. Creek Audio recommends

the EVOLUTION 50A or EVOLUTION 100A integrated amplifier as a perfect cosmetic and

performance match, but virtually any stereo amplifier with a line-level input and volume con-

trol should be OK. If you enable the EVOLUTION 50A's volume control, it is possible to just

use it with a Power Amplifier.

Connect the mains supply using the 3-core mains cord supplied. Push the 3 pin IEC plug

into the socket on the rear panel of the EVOLUTION 50CD and plug the other end into a

suitable wall socket. Do not overload the socket with too many connectors. Ask your dealer

for advice if in doubt.

Use a pair of good-quality stereo interconnects to join the analogue output of the DAC/CD

Player to the input of your amplifier. There are both un-balanced and balanced outputs avail-

able. Although it is possible to use both outputs simultaneously we do not recommend it,

as it can reduce the performance. NEVER use Balanced-to-Unbalanced cables such as an

XLR to RCA cable, as these will give poor performance and could damage the EVOLUTION

50CD.

Note: Balanced outputs can be connected directly to the EVOLUTION 50A amplifier and if the distance be-

tween them is greater than 5 metres, this may provide a better quality of sound. Balanced audio, using XLRs is

a professional standard and designed to eliminate unwanted noise or hum over long cable lengths. For shorter

cable runs it may not improve the sound of your system, because of the additional circuitry required, so please

experiment to see what works best. Just as with un-balanced interconnects, cable quality can affect the sound

quality. Ask your dealer for advice if you are not sure.

Output level:

The factory setting fixes the output level at 'Line Level (0dB max)', by default. If you wish to

change this to become variable, Pre-Amplifier Mode must be enabled through the start-up

Menu. To enable 'Preamplfier Mode' start with the EVOLUTION 50CD switched off. Press

the MENU button and hold it down simultaneously while pressing the power button on, to

reveal a hidden Menu.

The Setup Menu will display the following: 'Analogue Output' and 'Factory Defaults'.

To enable the EVOLUTION 50CD to have a volume controlled output - Select Analogue

Output by pressing the Play/Pause button. Press either the Track Back/Forward button until

Page: 2