Fiap 2710 Kullanım Kılavuzu - Sayfa 5

Havuz Pompaları Fiap 2710 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Fiap 2710 20 sayfaları.

Sayfayı Yazdır

FIAP Aqua Active Plus

Cleaning the pump

Unscrew the pump from the UVC water housing. Unscrew the pump lid by turning counter-clockwise,

then remove the rotor. Clean all components using clean water and a brush. After cleaning the pump,

reassemble in the reverse order.

Replacing the UVC lamp

For an optimum filter performance, we recommend to replace the UVC lamp after approx. 8000

operating hours.

Important: Only use lamps the identification and capacity data of which correspond to the information

on the type plate.

Assembly of the unit

Tighten the pump at the UVC water housing using the union nut. Ensure that the hose is not kinked.

Insert the UVC clarifying unit including the pump. Attach the top strainer casing and press it onto the

bottom strainer casing until the clamps engage in the bottom strainer casing. Important: Lead the

connection cable through the cable opening in the bottom strainer casing and route the cable such that

pinching is avoided.

Storage/Over-wintering

Remove the unit at temperatures below zero degrees centigrade. Thoroughly clean and check the unit

for damage. Store the unit immersed in water or filled with water at a frost-free place. Do not flood the

power plug!

Wearing parts

The UVC lamp and the rotor are wear parts and are excluded from the warranty.

Disposal

Dispose of the unit in accordance with the national legal regulations. The UVC lamp needs special

disposal. Ask your specialist dealer.

Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045

FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen

Tel: 09628 9213 0; Fax: 09628 9213 30;

www.fiap.com

FIAP Aqua Active Plus

Malfunctions

Malfunction

Cause

The unit is not operating

No mains voltage

Delivery or fountain height

Flow regulator excessively

insufficient or not consistent,

throttled

cloudy water

Nozzle blocked

Excessive pressure losses in

the hoses

Intake openings blocked

Rotor blocked

Pond extremely dirty

Quartz glass tube soiled

UVC lamp does not light up

UVC lamp defective

Unit switches off after a short

Water temperature too high

running period

Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045

FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen

Tel: 09628 9213 0; Fax: 09628 9213 30;

Remedy

Check mains voltage

Set flow regulator

Clean nozzle

Reduce hose length and

connecting parts to a minimum,

route hoses as straight as

possible

Clean housing

Clean rotor

Remove algae and leaves from

the pond, perform a partial

water change

Remove UVC filter and clean

the quartz glass tube

Replace the UVC lamp

Note maximum water

temperature of + 35 °C