ByFlo Products PG-IRT1602 Kullanıcı Kılavuzu - Sayfa 6

Termometre ByFlo Products PG-IRT1602 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ByFlo Products PG-IRT1602 9 sayfaları.

Sayfayı Yazdır

1. Switching from °C to °F

Product Cleaning Instructions

In order to ensure accurate measurements, it is recommended

to clean the device after every use.

Please use a cotton swab to dip 75% alcohol to wipe the

thermometer probe and remove any residue.

We recommend you to clean the probe for at least for five

seconds.

Then wipe the other components with a soft and dry cloth.

After cleaning, please ensure that

there is no visible dirt or residue on

your thermometer. Wait 10 minutes

before using.

The

device

can

for maximum of 40000 times.

Troubleshooting

Problem

When the power is

turned on, the

screen doesn't

display.

There may be dirt on

the sensor.

cleaned

Ensure the battery

polarity is the same as

the battery case.

Clean the device.

The interval for each

measurement should

be over 10 seconds.

Reasons

When the temperature is

higher than the

1. When the measurement

measurement range (more

than 43.0°C/109.4°F for

the forehead mode, and

over 93.2°C/199.76°F in

the object mode), the

screen will display "HI"

2. When the measurement

When the temperature is

lower than the

measurement range (less

than 34.0°C/93.2°F for the

forehead mode, and below

0°C/32°F in the object

mode), the screen will

display "Lo".

The limit of the operating

environment is 40°C/104°F

When using this product, the

for this device. When the

environment temperature cannot

environment temperature

be higher than 40°C/104°F.

exceeds this temperature,

the screen will show the

error "Er.H".

The lower limit of the

When using this product, the

operating environment is

environment temperature cannot

10°C/50°F for this device.

be lower than 10°C/50°F.

When the environment

temperature is below this

temperature, the screen

will show the error "Er.L".

When the environment

temperature changes

When the error "Err" is

rapidly for 5 degrees in

displayed, place the device in a

object mode, the screen

stable environment, and do not

will show the error "Err",

use for 30 minutes.

and the device will

automatically shutdown.

Solutions

probe is not properly placed

on the forehead, or the

measuring distance is too

far, the measured result may

be low.

probe is dirty, the measured

result may be low. Please

clean the probe following the

previous cleaning

instructions.