Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 31

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar), Kurulum Notu (36 sayfalar)

Position the installation bracket over the two standoffs and press down only on the top of the bracket to

Step 7

seat the DFC3 daughter card connectors on the module connectors. (See

When seating the DFC3 daughter card on the module connectors, DO NOT touch or apply any pressure

Caution

to the heat sinks. Press down only on the installation bracket.

Figure 22

Secure the DFC3 daughter card to the module through the stiffener bracket with the two long screws that

Step 8

you previously removed.

Install the remainder of the screws and the cap nuts to fully attach the DFC3 daughter card to the module:

Step 9

For the DFC3B and DFC3BXL daughter cards, install the remaining 6 screws and 2 cap nuts. (See

Figure

For the DFC3C and DFC3CXL daughter cards, install the remaining 4 screws, 2 cap nuts, and 1

standoff. (See

78-15893-08

Seating the DFC3 on the Module (WS-X6748-GE-TX Equipped with a Front Stiffener

Bracket)

WS-X5530

23.)

Figure

24.)

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

Installing the DFC3B and DFC3C Daughter Cards

Figure

22.)

Apply pressure to seat

DFC connectors. Do

not press on heat sinks