Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 9

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Kurulum Notu (46 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar), Kurulum Notu (36 sayfalar)

Press the DIMM down until it is secured by the spring clips. (See

Step 6

Figure 6

Step 7

When the DIMM is installed, check the two alignment holes and ensure that the spring retainer is visible.

If it is not, the DIMM is not seated properly. If the DIMM appears misaligned, carefully remove it and

reseat it in the socket. Push the DIMM firmly back into the socket until the retainer springs snap into

place.

Repeat

Step 8

Installing the MSFC2

The MSFC2 that shipped after November 2001 is physically smaller than the previous MSFC2.

Note

To install the MSFC2 on the supervisor engine, follow these steps:

Step 1

Align the MSFC2 with the standoffs on the supervisor engine. The MSFC2 shipped before

November 2001 will also align with the male standoff. (See

mounting holes on the MSFC2 are aligned with the remaining standoffs.

78-14357-02

Installing the DIMM

Step 3

through

Step 7

for the second (upper) DIMM.

Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note

Installing the MSFC2

Figure

6.)

Figure

7.) Make sure that the remaining