Digiplex NE DGP2-ZC1 Hızlı Başlangıç Kılavuzu

Güvenlik Sistemi Digiplex NE DGP2-ZC1 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Digiplex NE DGP2-ZC1 2 sayfaları.

NTRODUCTION

The DGP2-ZC1 is used to protect doors and windows.

Typically, a magnet (not included) is mounted on a door or

window and the contact switch is mounted on the door frame

or windowsill (see Figure 1 below). An open zone signal is

sent through the communication network to the control panel

when the magnet moves away from the reed switch

(included). When the magnet returns to its position close to

the reed switch, a zone restore signal is sent. The distance

between the magnet and the reed switch is determined by the

magnet's specifications.

Once it is connected to the network, assign the DGP2-ZC1 to

a zone in the control panel as described in Zone

Programming (refer to the appropriate control panel

Reference & Installation Manual).

The Addressable Door Contact can be connected to and

used with any Digiplex (DGP-48) and DigiplexNE (DGP-

NE96) control panel. Connect the DGP2-ZC1 to the

communication network as shown in Figure 1 below.

On-board Tamper Switch: Yes

Voltage Input:

Current Consumption:

Operating Temperature:

Number of Zones:

Power-up Indication:

Proper Operation:

Locate Indication:

Bus Fault Indication:

Compatibility:

Reed Switch:

Dimensions:

Figure 1: Connecting the DGP2-ZC1

OMPATIBILITY

PECIFICATIONS

9 to 16 VDC

14.2mA typical

0°C to 50°C (32°F to 122°F)

1 standard zone

Green LED illuminates

Red LED flashes

Green LED flashes

Green and red LEDs flash alternately

Any Digiplex or DigiplexNE control panel

Form A, (SPST) reed switch

73.7mm L x 20.3mm H x 30.5mm W

2.9" L x 0.8" H x 1.2" W