Note: Fabric/Device Manager cannot be used to configure this feature.
1. Log into the switch using either the management console or telnet.
2. Enter your network-admin privileged account by entering your login name and password
switch login: admin
Password: <admin password>
3. Enter the following to enter configuration mode:
switch# config terminal
4. Select the desired switch port:
switch(config)# interface fc 1/<1-20>
5. Select the desired switch port speed:
switch(config-if)# switchport speed ?
1000
1000 Mbps speed
2000
2000 Mbps speed
4000
4000 Mbps speed
Auto
Autosense speed
switch(config-if)# switchport speed <desired speed>
switch(config-if)# exit
switch(config)# exit
6. Copy the running configuration into the startup configuration by entering the following:
switch# copy running-config startup-config
Note: The running configuration overwrites the startup configuration.
In the following example, port 9 is being set to 2-Gbps:
switch login: admin
password: <admin password>
switch# config terminal
switch(config)# interface fc 1/9
switch(config-if)# switchport speed 2000
switch(config-if)# exit
switch(config)# exit
switch# copy running-config startup-config
C-SERIES MDS 9134 FABRIC SWITCH
The MDS 9134 switch has a base 34-port chassis to accommodate up to 32 full rate 4-Gbps and 2
10-Gbps fibre channel ports. Four configurations are available:
24 4-Gbps active ports with optional 8-port 4-Gbps and 2-port 10-Gbps software
expansion licenses
32 4-Gbps active ports with an optional 2-port 10-Gbps software expansion license
24 4-Gbps and 2 10-Gbps active ports; a 48-port stackable solution is available with the
purchase of two of these products.
32 4-Gbps and 2 10-Gbps active ports; a 64-port stable solution is available with the
purchase of two of these products.
17
MDS Multilayer Director & Multilayer Fabric Switches Release Notes