Digital Acoustics INT-IP-2GANG Başlangıç Kılavuzu - Sayfa 4

İnterkom sistemi Digital Acoustics INT-IP-2GANG için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Digital Acoustics INT-IP-2GANG 4 sayfaları.
Ayrıca Digital Acoustics INT-IP-2GANG için: Başlangıç Kılavuzu (3 sayfalar)

Sayfayı Yazdır

Digital Acoustics INT-IP-2GANG Başlangıç Kılavuzu

• Click on the IP Endpoint to be configured (match the "Icom ID" column to the

Intercom's previously recorded ID#)

• If Endpoint Defaults have been setup,

click the Defaults button to copy them in

• Enter a descriptive name into the

Location Name field

• Check the DHCP option or uncheck it to

enter a Static IP

• If the Endpoint will connect to this

TalkMaster Server, check the

Authorized IP Endpoint option

• Either select the Server IP from the

dropdown or enter the IP Address of the

TalkMaster Server

• Enter the default port of 3000

Select the Options 1 tab

• Relay Mode – If the relay will be used to activate an electronic door strike, select

Door Relay Output from the dropdown

• Use UDP/RTP – Select this option to use the UDP/RTP protocol for sending and

receiving audio instead of the TCP protocol

• Full Duplex – Select this option to enable Full Duplex operation instead of Half

Duplex operation

Select the Options 2 tab

• Audio Profile – Select the INT-IP-2GANG audio profile if using full duplex or

select the Half Duplex audio profile

Change any additional IP Endpoint configuration options and then click SAVE.

The device will reboot and connect to TalkMaster in about 20 seconds. The Call

button LED will begin flashing rapidly and after 30 seconds, will be on solid

indicating that the Endpoint is connected to TalkMaster.

IP7 and Digital Acoustics® are trademarks of Digital Acoustics LLC.

Other trademarks are the property of their respective owners.