Digital Acoustics IP7-SS20 Referans Kılavuzu - Sayfa 14

Amplifikatör Digital Acoustics IP7-SS20 için çevrimiçi göz atın veya pdf Referans Kılavuzu indirin. Digital Acoustics IP7-SS20 20 sayfaları. Ip paging amplifier
Ayrıca Digital Acoustics IP7-SS20 için: Başlangıç Kılavuzu (4 sayfalar)

Sayfayı Yazdır

1. Ip Address

 Attach the detachable surface mount plate to the back of the

unit using the provided screws. The two mounting holes of the

surface mount plate should be above the

J1, J2, and J3 connectors

 Attach two (2) #8 pan head screws 2

inches (52 mm) apart and screw in to

within ¼"

 Place the mounting holes of the IP7-SS20

over the #8 screws

 Attach one (1) #8 screw to the remaining hole at the bottom of

the mounting plate

Setting Volume Levels

The IP7-SS20 supports seven volume levels for an attached speaker.

 Press the "+" or "-" Button one time to increase or decrease the

speaker volume

 If no audio is playing, a high frequency beep is heard when the

volume "+" is pressed and a low frequency beep is heard when

the volume "-" is pressed

 Pressing the "-" or "+" button seven times sets the unit at its

lowest or highest setting.

 Refer to the software manuals for setting the volume via

software.

Software Configuration

IP Address

Refer to the software manuals for instructions on setting the IP

address information for the IP7-SS20

Options

Refer to the software manuals for instructions on setting the "Remote

Listen Disable" option in the IP7-SS20: