Shimano deore XT Teknik Servis Talimatı - Sayfa 2

Bisiklet Aksesuarları Shimano deore XT için çevrimiçi göz atın veya pdf Teknik Servis Talimatı indirin. Shimano deore XT 9 sayfaları. Front derailleur for triple
Ayrıca Shimano deore XT için: Servis Talimatları Kılavuzu (2 sayfalar)

Sayfayı Yazdır

with the BR-M765 (calipers), ST-M765 (brake lever), SM-RT77 (rotor) and Shimano pad

unit.

• Obtain and read the service instructions carefully prior to installing the parts. Loose,

worn, or damaged parts may cause injury to the rider.

We strongly recommend only using genuine Shimano replacement parts.

• Read these Technical Service Instructions carefully, and keep them in a safe place for

later reference.

CAUTION

• M07-S brake pads are designed to reduce the amount of noise which is

generated between the pads and the rotor when the brakes are operated.

A longer running-in period is required for this type of pad compared to

M06 pads.

I Handling the mineral oil

• Use safety glasses when handling, and avoid contact with eyes. Contact with eyes may

result in irritation.

In the event of eye contact, flush with fresh water and seek medical assistance

immediately.

• Use gloves when handling. Contact with skin may cause a rash and discomfort.

In the event of skin contact, wash well with soap and water.

• Inhalation of oil mist or vapors may cause nausea. Cover nose and mouth with a

respirator type mask and use in a well ventilated area.

If mist or vapor is inhaled, go immediately to an area with fresh air. Cover up with a

blanket. Stay warm and stable and seek professional medical advice.

• Do not drink. May cause vomiting or diarrhea.

• Keep out of reach of children.

• Do not cut, heat, weld or pressurize the oil container, as this may cause explosion or fire.

• Disposal of Used Oil : Follow local county and/or state codes for disposal. Use care

when preparing oil for disposal.

• Directions : Keep the container sealed to prevent foreign objects and moisture from

getting inside, and store it in a cool, dark area away from direct sunlight or

heat.

I Burn-in period

• Disc brakes have a burn-in period, and the braking force will gradually increase as the

burn-in period progresses. Make sure that you are aware of any such increases in

braking force when using the brakes during the burn-in period. The same thing will

happen when the brake pads or rotor are replaced.

I When cleaning with a compressor

• If disassembling the caliper body to clean the internal parts using a compressor, note

that moisture from the compressed air may remain on the caliper components. Let the

caliper components dry sufficiently before reassembling the calipers.

Note

• When the bicycle wheel has been removed, it is recommended that pad spacers should

be installed. The pad spacers will prevent the piston from coming out if the brake lever is

depressed while the wheel is removed.

• If the brake lever is depressed without the pad spacers installed, the pistons will protrude

further than is normal. Use a flat-tipped screwdriver or similar tool to push back the brake

pads, while being careful not to damage the surfaces of the brake pads. (If the brake

pads are not installed, push the pistons straight back in, while being careful not to

damage them.)

If it is difficult to push the brake pads or pistons back, remove the reservoir tank cover

and then try again. (Note that some oil may overflow from the reservoir tank at this time.)

• Use isopropyl alcohol, soapy water or a dry cloth when carrying out cleaning and

maintenance of the brake system. Do not use commercially-available brake cleansers or

silencing agents, as they can cause damage to parts such as seals.

• Do not remove the pistons when disassembling the calipers.

• If the rotor is worn, cracked or warped, it should be replaced.

• Parts are not guaranteed against natural wear or deterioration resulting from normal use.

• For maximum performance we highly recommend Shimano lubricants and maintenance

products.

In order to realize the best performance, we recommend that the following

combination be used.

Caliper

Brake Lever

Rotor

Hose

BR-M765

Cable Supporter

ST-M765

Mineral Oil

SM-RT77

Brake pad

unit

SM-BH62/63

M07S RESIN

SM-HANG

SM-DB-OIL

Resin Pads

M07-S

Metal Pads

M06