Shimano ST-RS200 Bayi El Kitabı - Sayfa 21
Bisiklet Aksesuarları Shimano ST-RS200 için çevrimiçi göz atın veya pdf Bayi El Kitabı indirin. Shimano ST-RS200 48 sayfaları. Shifting lever
Sayfayı Yazdır
MAINTENANCE
Assembling the bracket body and lever body
Assembling the bracket body and lever body
1
2
(A)
3
(z)
(B)
4
Insert the lever into the bracket.
Insert the end of the return spring into
the notch.
Align the axle holes, set the Shimano
(A)
original E-ring removal tool [1] in the
position shown in the illustration, and
then press-fit the lever axle.
(z)
Remove the Shimano original E-ring
removal tool [1], and then use the
Shimano original E-ring removal tool [2]
to install the E-ring.
(A)
Do not press-fit the lever axle
from this direction.
Otherwise, it may damage the
bracket body.
21
(A)
Return spring
(A)
E-ring groove
(B)
Shimano original E-ring removal
tool [1]
TECH TIPS
•
The correct direction for the lever axle is
for the E-ring groove to face up.
•
Check that the surface of the bracket body
is flat so the E-ring of the lever axle can fit
into the groove properly.
(A)
Shimano original E-ring removal
tool [2]
NOTE
Do not use the removed E-ring again.
Be sure to use a new E-ring.