Shimano Ultegra 6770 Series Kılavuzlar - Sayfa 15

Bisiklet Shimano Ultegra 6770 Series için çevrimiçi göz atın veya pdf Kılavuzlar indirin. Shimano Ultegra 6770 Series 24 sayfaları.

Sayfayı Yazdır

Once the electric wires have been routed, secure junction (B) underneath the bottom bracket shell.

Tightening torque:

1.5 - 2 N·m {13 - 18 in. lbs.}

Next, install the electric wire cover to the frame. In order to make sure that the

electric wire cover is securely installed, clean the frame with alcohol or some other

cleaning agent to remove any grease or other substances before installing the cover.

Place the electric wire cover over the electric wires, and then attach it to the frame.

Checking connections

After connecting the electric wires to all of the components, install the battery and check the

operation.

Operate the shifting switches and check that the front derailleur and rear derailleur both operate.

Note:

* If not installing the chain at this point, be sure to operate shifting switch (X) for the left lever once

or more to set the front derailleur to the larger chainring position when installing the chain. After

this, be sure to remove the battery.

Disconnection of the electric wires

Use the wide end of the TL-EW02 special tool to disconnect the electric

wires. If you pull too firmly on the connectors, problems with operation

may occur. Insert the special tool so that the flat side is facing toward

the derailleur, and then tilt it so as to pull out the connector of the

electric wire.

Junction (B) fixing bolt

(10.5mm or 15mm)

(3mm Allen key)

Shifting switch (X)

FD-6770

RD-6770

When disconnecting the electric wire from a lever, face the flat side toward the lever. When disconnecting the connector of

junction (A) or junction (B), insert the special tool so that the flat side is facing toward junction.

ST-6770

* Run any excess length of electric wire along the handlebar, and use cable ties or similar to secure the electric wire to the

handlebar.

$ Rear junction: Connection of junction (B)

Built-in type (SM-JC41)

First pass the electric wires for junction (A), the battery mount,

the front derailleur and the rear derailleur through the holes in

the frame into the bottom bracket shell.

* The electric wires have a correct way of being inserted. Make

sure that you insert them from the direction shown in the

illustration.

Electric wire for front derailleur

Electric wire for rear derailleur

Electric wire for junction (A)

Electric wire for battery mount

SM-JC40

Wire holder

Bottom bracket shell

SM-JC41