Siemens SIMATIC NET Kurulum Kılavuzu - Sayfa 19

Endüstriyel Ekipmanlar Siemens SIMATIC NET için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Siemens SIMATIC NET 48 sayfaları. Network components bus terminal
Ayrıca Siemens SIMATIC NET için: Kullanım Talimatları Kılavuzu (29 sayfalar), Kullanım Talimatları Kılavuzu (50 sayfalar), Kullanım Talimatları Kılavuzu (28 sayfalar), Montaj Talimatları Kılavuzu (6 sayfalar), Ürün Bilgileri (6 sayfalar), Kurulum Kılavuzu (40 sayfalar), Kurulum Kılavuzu (50 sayfalar), Kurulum Kılavuzu (40 sayfalar), Referans Kılavuzu (14 sayfalar), Kurulum Kılavuzu (34 sayfalar), Kullanım Talimatları Kılavuzu (32 sayfalar)

Installing the Device

2.3.2 Mounting the Device to a Panel

To secure the device to a standard 48 cm (19 in) rack, do the following:

Note

The device can be ordered with the communication ports located at the front or rear

of the device. Placing the ports at the rear allows all data and power cabling to be

installed and connected at the rear of the rack.

2.3.2

Mounting the Device to a Panel

For panel installations, the RUGGEDCOM M2100F can be equipped with panel

adapters pre-installed on each side of the chassis. The adapters allow the device to

be attached to a panel using screws.

Make sure the rack mount adapters are installed on the correct side of the

chassis.

•

To make the modules and ports accessible, install the rack mount adapters

at the rear of the chassis

•

To make the management ports and LEDs accessible, install the rack mount

adapters at the front of the chassis

Note

The chassis features multiple mounting holes, allowing the rack mount adapters

to be installed up to 25 mm (1 in) from the face of the device.

Rear

Front

Rack Mount Adapter

Figure 2.1

Rack Mount Adapters

If required, install adapters on the opposite side of the device to protect from

vibrations.

Insert the device into the rack.

Secure the adapters to the rack using the supplied hardware.

Installation Manual, 04/2022, C79000-G8976-1342-09

RUGGEDCOM M2100F