Siemens SIMATIC NET Kurulum Kılavuzu - Sayfa 20

Endüstriyel Ekipmanlar Siemens SIMATIC NET için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Siemens SIMATIC NET 48 sayfaları. Network components bus terminal
Ayrıca Siemens SIMATIC NET için: Kullanım Talimatları Kılavuzu (29 sayfalar), Kullanım Talimatları Kılavuzu (50 sayfalar), Kullanım Talimatları Kılavuzu (28 sayfalar), Montaj Talimatları Kılavuzu (6 sayfalar), Ürün Bilgileri (6 sayfalar), Kurulum Kılavuzu (40 sayfalar), Kurulum Kılavuzu (50 sayfalar), Kurulum Kılavuzu (40 sayfalar), Referans Kılavuzu (14 sayfalar), Kurulum Kılavuzu (34 sayfalar), Kullanım Talimatları Kılavuzu (32 sayfalar)

To mount the device to a panel, do the following:

2.4

Connecting the Failsafe Alarm Relay

The failsafe relay can be configured to latch based on alarm conditions. The NO

(Normally Open) contact is closed when the unit is powered and there are no active

alarms. If the device is not powered or if an active alarm is configured, the relay

opens the NO contact and closes the NC (Normally Closed) contact.

Note

Control of the failsafe relay output is configurable through RUGGEDCOM M2100F.

One common application for this relay is to signal an alarm if a power failure occurs.

For more information, refer to the "RUGGEDCOMROS Configuration Manual" for the

RUGGEDCOM M2100F.

The following shows the proper relay connections.

RUGGEDCOM M2100F

Installation Manual, 04/2022, C79000-G8976-1342-09

Place the device against the panel and align the adapters with the mounting

holes.

Screw

Panel Adapter

Figure 2.2

Panel Mounting

Install the supplied screws to secure the adapters to the panel.

2.4 Connecting the Failsafe Alarm Relay

1 1

Installing the Device

1 1