Epson BrightLink 485Wi Manuel - Sayfa 5

Projektör Epson BrightLink 485Wi için çevrimiçi göz atın veya pdf Manuel indirin. Epson BrightLink 485Wi 21 sayfaları. Lamp and status information
Ayrıca Epson BrightLink 485Wi için: Buradan Başlayın Kılavuzu (6 sayfalar), Kullanım Kılavuzu (47 sayfalar), Bağlantı Kılavuzu (6 sayfalar), Kurulum Kılavuzu (5 sayfalar), Montaj Şablonu (5 sayfalar), Teknik Özellikler (6 sayfalar), Uygunluk Beyanı (4 sayfalar), Teknik Özellikler (6 sayfalar), Kurulum El Kitabı (3 sayfalar), Kurulum El Kitabı (2 sayfalar), Kurulum El Kitabı (5 sayfalar), Buradan Başlayın Kılavuzu (6 sayfalar)

This process takes under a minute and once complete, you should have an image

from whatever source you have connected to the projector provided that source

is active (powered on and not in sleep mode).

There are two locations on the displayed image where you can see which input

you have selected. Once an image from your source appears, the upper right

hand corner will have information on what input you have selected. If you have a

blue screen with no image from your PC or source device, look in the bottom left

hand corner to determine which input you have selected.

Step 2

– Use your interactive pen(s). Once you have the image from the PC

displayed on the viewing surface, you will need to retrieve and power on your

interactive pen(s). You have two interactive pens that come with the Epson

485wi. Each is marked with either a blue or orange end-cap. The power switch is

located on the underside of the back end of the pen(s). See the pen image below

for details.

Once the pen has been powered on, it will take a few seconds for the projector

and pen to communicate and activate the interactive functionality. You will know

that the interactive functions are active when you approach the board with the

pen and the cursor moves towards the pen tip.

-4-