Epson BrightLink 485Wi Manuel - Sayfa 4

Projektör Epson BrightLink 485Wi için çevrimiçi göz atın veya pdf Manuel indirin. Epson BrightLink 485Wi 21 sayfaları. Lamp and status information
Ayrıca Epson BrightLink 485Wi için: Buradan Başlayın Kılavuzu (6 sayfalar), Kullanım Kılavuzu (47 sayfalar), Bağlantı Kılavuzu (6 sayfalar), Kurulum Kılavuzu (5 sayfalar), Montaj Şablonu (5 sayfalar), Teknik Özellikler (6 sayfalar), Uygunluk Beyanı (4 sayfalar), Teknik Özellikler (6 sayfalar), Kurulum El Kitabı (3 sayfalar), Kurulum El Kitabı (2 sayfalar), Kurulum El Kitabı (5 sayfalar), Buradan Başlayın Kılavuzu (6 sayfalar)

In most cases, this USB cable has been installed by the

AV Team

and will be green

in color. The 'A' end of the cable will plug into any available USB port on your PC.

The other end of the cable, the 'B' end, will plug into a wall plate located near the

AVP.

From this point the signal travels over in-wall cabling to the projector.

Again, only

a GCS Technician will be able to access the connection points either in the wall or

at the projector.

If you have issues with your projector not displaying the image from your PC, or

your interactive pen stops working, check these connections behind your PC and

at the wall prior to opening a ticket. If these connections are secured properly

and you still have issues, please open a ticket with the

AV Team

with Technology

Services.

Listed below are the steps necessary to operate your Epson 485wi in a classroom

environment.

Step 1

– Power on the projector. You can reach up and push the power button on

the projector or you can use the power button located on the remote. In either

case, you should hear the projector beep and the amber light should turn green

and start blinking while the power up cycle runs its course.

-3-