Epson BrightLink 485Wi 매뉴얼 - 페이지 4

{카테고리_이름} Epson BrightLink 485Wi에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson BrightLink 485Wi 21 페이지. Lamp and status information
Epson BrightLink 485Wi에 대해서도 마찬가지입니다: 여기에서 시작하기 매뉴얼 (6 페이지), 운영 매뉴얼 (47 페이지), 연결 매뉴얼 (6 페이지), 설치 매뉴얼 (5 페이지), 마운팅 템플릿 (5 페이지), 사양 (6 페이지), 적합성 선언 (4 페이지), 사양 (6 페이지), 설치 핸드북 (3 페이지), 설치 핸드북 (2 페이지), 설치 핸드북 (5 페이지), 여기에서 시작하기 매뉴얼 (6 페이지)

In most cases, this USB cable has been installed by the

AV Team

and will be green

in color. The 'A' end of the cable will plug into any available USB port on your PC.

The other end of the cable, the 'B' end, will plug into a wall plate located near the

AVP.

From this point the signal travels over in-wall cabling to the projector.

Again, only

a GCS Technician will be able to access the connection points either in the wall or

at the projector.

If you have issues with your projector not displaying the image from your PC, or

your interactive pen stops working, check these connections behind your PC and

at the wall prior to opening a ticket. If these connections are secured properly

and you still have issues, please open a ticket with the

AV Team

with Technology

Services.

Listed below are the steps necessary to operate your Epson 485wi in a classroom

environment.

Step 1

– Power on the projector. You can reach up and push the power button on

the projector or you can use the power button located on the remote. In either

case, you should hear the projector beep and the amber light should turn green

and start blinking while the power up cycle runs its course.

-3-