Epson BrightLink 485Wi Руководство - Страница 4

Просмотреть онлайн или скачать pdf Руководство для Проектор Epson BrightLink 485Wi. Epson BrightLink 485Wi 21 страница. Lamp and status information
Также для Epson BrightLink 485Wi: Начните здесь Руководство (6 страниц), Руководство по эксплуатации (47 страниц), Руководство по подключению (6 страниц), Руководство по установке (5 страниц), Монтажный шаблон (5 страниц), Технические характеристики (6 страниц), Декларация о соответствии (4 страниц), Технические характеристики (6 страниц), Руководство по установке (3 страниц), Руководство по установке (2 страниц), Руководство по установке (5 страниц), Начните здесь Руководство (6 страниц)

Печатать страницу
Epson BrightLink 485Wi Руководство
In most cases, this USB cable has been installed by the
AV Team
and will be green
in color. The 'A' end of the cable will plug into any available USB port on your PC.
The other end of the cable, the 'B' end, will plug into a wall plate located near the
AVP.
From this point the signal travels over in-wall cabling to the projector.
Again, only
a GCS Technician will be able to access the connection points either in the wall or
at the projector.
If you have issues with your projector not displaying the image from your PC, or
your interactive pen stops working, check these connections behind your PC and
at the wall prior to opening a ticket. If these connections are secured properly
and you still have issues, please open a ticket with the
AV Team
with Technology
Services.
Listed below are the steps necessary to operate your Epson 485wi in a classroom
environment.
Step 1
– Power on the projector. You can reach up and push the power button on
the projector or you can use the power button located on the remote. In either
case, you should hear the projector beep and the amber light should turn green
and start blinking while the power up cycle runs its course.
-3-