Cisco 7961G - IP Phone VoIP Yönetim Kılavuzu - Sayfa 14

IP Telefon Cisco 7961G - IP Phone VoIP için çevrimiçi göz atın veya pdf Yönetim Kılavuzu indirin. Cisco 7961G - IP Phone VoIP 16 sayfaları. Unified communications manager 9.0 (sccp and sip)
Ayrıca Cisco 7961G - IP Phone VoIP için: Kullanıcı Kılavuzu (21 sayfalar), Kullanıcı Kılavuzu (25 sayfalar), Hızlı Referans (2 sayfalar), Kullanıcı Kılavuzu (4 sayfalar), Veri Sayfası (8 sayfalar), Kullanıcı Kılavuzu (4 sayfalar), Kullanıcı Kılavuzu (13 sayfalar), Yönetim Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (13 sayfalar), Telefon Kılavuzu (30 sayfalar), Kullanıcı Kılavuzu (13 sayfalar), Manuel (12 sayfalar), Kullanıcı Kılavuzu (6 sayfalar)

Phone Startup Process Verification

After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by cycling

through the following steps.

1 These buttons flash on and off in sequence:

2 Some or all of the line keys flash amber in sequence.

Caution

If the line keys flash red in sequence after flashing amber, do not power down the phone until the sequence

of red flashes completes. This sequence can take several minutes to complete.

3 Some or all of the line keys flash green.

Normally, this sequence takes just a few seconds. However, if the phone's Flash memory is erased or the

phone load is corrupted, the sequence of green flashes will continue while the phone begins a software

update procedure. If the phone performs this procedure, the following buttons light to indicate progress:

4 The phone screen displays the Cisco Systems, Inc., logo screen.

5 These messages appear as the phone starts:

6 The phone screen displays:

Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco

Unified Communications Manager 9.0 (SCCP and SIP)

• Headset (only if the handset is off-hook when the phone powers up. Hang up the handset within 3

seconds to have the phone launch its secondary load. To continue with the primary load, leave the

handset off-hook.)

• Mute

• Speaker

• Headset—Phone is waiting for the network and completing CDP and DHCP configuration. A DHCP

server must be available in your network.

• Mute—Phone is downloading images from the TFTP server.

• Speaker—Phone is writing images to its Flash memory.

• Verifying Load (if the phone load does not match the load on the TFTP server). If this message

appears, the phone starts up again and repeats step 1 through step 4 above.

• Configuring IP

• Updating the Trust List

• Updating Locale

• Configuring Unified CM List

• Registering

• Current date and time

• Primary directory number

Cisco Unified IP Phones Installation