Cisco 8831 Kullanıcı Kılavuzu - Sayfa 4

IP Telefon Cisco 8831 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cisco 8831 6 sayfaları. Hard factory reset
Ayrıca Cisco 8831 için: Özellikler (17 sayfalar), Kurulum Kılavuzu (14 sayfalar), Dağıtım Kılavuzu (6 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar), Hızlı Referans Kılavuzu (6 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (13 sayfalar), Sorun Giderme Kılavuzu (3 sayfalar)

Sayfayı Yazdır
Cisco 8831 Kullanıcı Kılavuzu

PLACING A PHONE CALL

1.
Enter a phone number (10-digit phone number) you want to reach
2.
Press [Dial] or speakerphone button

ANSWERING CALLS

1.
press [Answer] softkey,or press the speakerphone button

ENDING A CALL

1.
Press [End Call] or speakerphone button

MUTING A CALL

1.
Press the Mute
Press the Mute
2.
Note: Sound Base lights turn from red to green when not muted, and the DCU mute button is no longer red
Conference
Before You Begin
Before you can add a party to the conference, you must be on an active call and not on hold.
Step 1 Press Conf.
Step 2 Enter the phone number or speed-dial number for the party you want to add.
If you have several held calls, you can press Calls to display a caller list and add a caller to the conference.
Step 3 After the new party answers, press Conf.
The conference begins.
Step 4 (Optional) Repeat these steps to add more parties, if desired.
View Conference participants
Step 1 press ConfList to view a listof current participants
Remove Conference participants
Step 1 While in a conference, press ConfList to view a list of participants.
Step 2 Highlight the participant that you want to remove and then press Remove.

Create conference with two calls on same line

Step 1 With two connected calls on the same line, select a call to make it the active call.
The second call is put on hold.
Step 2 Press Conference.
Step 3 Press Calls to view the call list and select the caller to add to the conference.
Step 4 Wait for the call to connect.
Step 5 Press Conference to add the participant to your call.
The conference begins.
Divert
Step 1 Press Divert to send an incoming call to Voice Mail.
Note: available if extension is setup to receive voice mail
to disconnect the current call
button on the Sound Base or DCU. (Off =
button again to deactivate.
On =
) (solid red LED light when muted.
Pg. 4