ActronAir LM-ZC-2G Kullanım Kılavuzu - Sayfa 10

Kontrolör ActronAir LM-ZC-2G için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ActronAir LM-ZC-2G 12 sayfaları.

Operation Manual

13. Troubleshooting

Condition

The system does not start.

Air does not flow. (Indoor Unit)

OFF is displayed on my zone

controller and I cannot turn the

On.

For any assistance with your ESP Ultima System, do not hesitate to contact our

• Check that 5 minutes has passed from the time you turned the

system on, as the system has in-built safety timers.

• Check thermostat settings are correct.

• Check the thermostat Setpoint is set low enough for cooling or high

enough for heating.

• Check that the Wall Controller is set to correct mode for COOL /

AUTO / HEAT.

• Check if the unit is set in the correct mode COOL / AUTO / HEAT.

• Check your Zone Controller is turned On. If using zone sensor,

ensure your zone is turned On at the Wall Controller.

• During defrost cycle of the outdoor unit (in HEAT mode), the

indoor fan will not operate.

• This means the Wall Controller is turned Off. First turn on your air

conditioner at the Wall Controller. You will now be able to turn on

your Zone Controller.

Customer Care Team for technical support on free call number:

Operation Manual LM-ZC-2 Wall Controller

Document No. 0525-082 Ver. 1 190918

Causes or Check Points

Defrost cycle is indicated when HEAT is flashing on the Wall

Controller display.

1800 119 229

Zone Controller

Page 10