ActronAir LM-ZC-2G Kullanım Kılavuzu - Sayfa 8

Kontrolör ActronAir LM-ZC-2G için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ActronAir LM-ZC-2G 12 sayfaları.

Operation Manual

3. Press the

Button again to select HIGH, MED, LOW fan speed.

4. All open zones will circulate air throughout your home.

5. If you wish to shut any particular zone in this mode, simply turn Off zone by pressing the designated zone button.

Zone LED will go off.

FAn will be displayed on zone control display when the Master Wall Controller is set to circulation operation. During

this period, zone damper will be in fully open position for maximum air circulation.

If you do not want the unit to circulate airflow in your room in this mode, simply press the

controller or turn your zone Off at the Master Wall Controller.

11. Zone Temperature Display

NOTE

Room temperature displayed can be the temperature at a zone controller or at a remote sensor or the average of both

depending on your installation set up.

To Check Temperature at Master Wall Controller

Average Room Temperature Display

1. Press the

for 3 seconds. INSIDE,

currently on.

Checking Individual Zone Temperature

1. While INSIDE,

• INSIDE and

C will turn Off. The selected zone LED and "." flashes.

• During this time, the selected zone temperature is displayed.

2. To check another zone, simply press other zone button while the previous zone LED and "." are flashing.

Buttons on the Master Wall Controller and the average room temperature will be displayed

C and ". "will be flashing. The temperature displayed is the average of all zones that are

C and "." are flashing, press the zone to be checked.

Operation Manual LM-ZC-2 Wall Controller

Document No. 0525-082 Ver. 1 190918

Zone Controller

Button on your zone

Page 8