Cisco 1100 Series Kurulum ve Yükseltme - Sayfa 2

Ağ Yönlendiricisi Cisco 1100 Series için çevrimiçi göz atın veya pdf Kurulum ve Yükseltme indirin. Cisco 1100 Series 15 sayfaları. Terminal gateway
Ayrıca Cisco 1100 Series için: Manuel (12 sayfalar), Donanım Kurulum Kılavuzu (44 sayfalar)

Sayfayı Yazdır

Accessing Internal Modules

Replacing the Chassis Cover

The Cisco 1100 Series ISRs have a removable cover.

Do not run the router with the cover off. Doing so can cause the router to overheat very quickly.

Use a number-2 Phillips screwdriver to perform the following tasks.

Removing the Cover

To remove the cover, perform the following steps.

Step 1

Read the Safety Warnings and disconnect the power supply before you perform any module replacement.

Step 2

Confirm the router is turned off and disconnected from the power supply or power supplies. If a redundant power is

used, disconnect from the redundant power supply.

Step 3

Place the chassis on a flat surface.

Step 4

Remove all the screws on the both sides of the router; seven on each side.

Step 5

Pull the cover to disengage the slots along the front (bezel) edge of the chassis, as shown in the figure below.

Figure 1: Removing the Cover

Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router

Installing and Upgrading Internal Modules and FRUs

Slots