Cisco 1100 Series Kurulum ve Yükseltme - Sayfa 4

Ağ Yönlendiricisi Cisco 1100 Series için çevrimiçi göz atın veya pdf Kurulum ve Yükseltme indirin. Cisco 1100 Series 15 sayfaları. Terminal gateway
Ayrıca Cisco 1100 Series için: Manuel (12 sayfalar), Donanım Kurulum Kılavuzu (44 sayfalar)

Sayfayı Yazdır

Locating Internal and External Slots for Modules

Installing the Internal PoE Daughter Card

Use the following procedure to install an Internal PoE daughter card:

Step 1

Read the Safety Warnings and disconnect the power supply before you perform any module installation.

Step 2

Confirm the router is turned off and disconnected from the power supply.

Step 3

Open the chassis according to the instructions in the Removing the Chassis section.

Step 4

Locate the three metal standoff holes, and install the metal standoffs into the three holes. Make sure that the standoffs

are straight when installed. Tighten them gently but firmly, to a torque of 6-8 in-lbf.

Step 5

Place the PoE daughter card on top of the three metal standoffs, lining up the screw holes in the PoE daughter card with

the metal standoffs.

Step 6

Gently push the PoE daughter card down towards the system board until it is firmly fixed.

Step 7

Insert the three M3 (48-0530-01) screws provided, through the PoE daughter card and into the metal standoffs. Tighten

the screws using a torque of 5 in-lb.

Step 8

Close the chassis cover according to the instructions in the Replacing the Cover section, and connect the power supply

cable.

Figure 3: Internal PoE Daughter Card Assembly

Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router

Screws

Metal Standoffs

Installing and Upgrading Internal Modules and FRUs

PoE Module

PoE Daughter Card