Cisco 3745 Hızlı Başlangıç Kılavuzu - Sayfa 21
Ağ Yönlendiricisi Cisco 3745 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 3745 33 sayfaları. Non-proprietary security policy
Ayrıca Cisco 3745 için: Çözüme Genel Bakış (16 sayfalar), Yükseltme Talimatları (30 sayfalar), Kullanıcı Kılavuzu (48 sayfalar), Kurulum Kılavuzu (12 sayfalar)
Sayfayı Yazdır
Step 11 After the following messages appear, press Return to save the basic configuration:
The following configuration command script was created:
hostname 3745
enable secret 5 $1$Ksjf$za4T2lb3ARS5d1PHVzW5A0
enable password xxxx
line vty 0 4
password xxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
full-duplex
ip address 10.1.1.1 255.255.0.0
!
interface FastEthernet0/1
shutdown
no ip address
!
end
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Press RETURN to get started! RETURN
Step 12 The user prompt is displayed:
3745>
When you have completed the basic configuration tasks, your Cisco router is ready to configure for specific functions. See the
"Where to Go Next" section on page 24
Initial Configuration Using the CLI (Manual Configuration)
This section shows how to bring up a command-line interface (CLI) prompt for configuration using the CLI, and it directs you
to documentation for the CLI configuration.You can use the CLI if you see the following messages at the end of the startup
sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file have been installed on the router at the factory. To use
SDM to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager" section on
page 19.
For interface numbering information, see the "Interface Numbering" section on page 22.
for information about locating documentation for advanced configuration procedures.
21