CAB 5314 Operatör El Kitabı - Sayfa 14

Etiket makinesi CAB 5314 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. CAB 5314 17 sayfaları. Vacuum-belt applicator

Adjustments

Waiting position of the label

Label transport / Reflex sensor

Fig.10

In the setup the operation mode "Blow on" must be selected to gain access to the parameter "Blow time".

After reaching the reflex sensor (1) and the detection point (3) the transportation process continues a certain time to

ensure that the label (2) it is applied by the pinch roller (4). The time and distance of this process can be adjusted vie

the parameter:

> Blow time

A higher value means the label will be transported further.

200 ms represents about 10 mm.

Follow up feed of the label

After the label (2) has left the the reflex sensor area (3) the application will continue transportation will continue to

apply the label to the product. This length of this transportation process can be ajusted via the parameter:

> Support del. ON

4.3

Signals

The signal DREE will start the print the label and move it to the reflex sensor before the pinch roller.

•

The signal START will feed the label past the reflex sensor including the follow up transportation of the pinch

•

roller.

In the apply-mode "Apply - Print" will print the next label of the print job after it has applied the previous label.

In the apply-mode "Print - Apply" the printing of a new label depends on the signal DREE.

Signal

Name

DREE

START

Table 2

Description

without applicator

Starting of the printing pro-

cess dependant on: Supe-

rior control has confirmed

the ETE signal, previous

label has been taken from

the peel-off position.

Pin assignment of the I/O interface  Interface description of the label printer Hermes+

with applicator

Print first label

in mode "Apply-Print"

Print/application start signal

Activation / Active State

Switch on +24V between

Pin 1 and Pin 25

+24V between Pin 13 and Pin 25