CAB 5314 Operatör El Kitabı - Sayfa 15

Etiket makinesi CAB 5314 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. CAB 5314 17 sayfaları. Vacuum-belt applicator

Error Messages

5.1

For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.)  Operator's manual of the printer

Error treatment:

 Clear the error results.

 Press the feed key to synchronize the label feed, remove the peeled labels manually.

 Press the pause key to quit the error state.

After error correction, the printing of the label causing the error will be repeated.

5.2

The following table contains an overview of error messages and their possible causes. It also suggests methods to

resolve the problem:

Error Message

Vac. plate empty

Upper position

Air pressure ins.

Table 3

Error messages of the applicator

Error treatment:

 Clear the error results.

 Press the pause key to quit the error state.

Note!

When receiving errors check the settings and adjustment parameters in the service manual.

 After error correction, the printing of the label causing the error cannot be repeated without re-starting the print

job.

Except at the error " Vac. plate empty". In this case, the last label will be printed again after the error state

has been exited with the pause key and by then pressing the Enter button

 In the application mode "Apply/Print" sends the signal "Print first label" and pressing the button

printed label to the applicator.

Possible Cause

The Label has been lost on the way or at the waiting position infront of the princh roller

before the START signal was received.

The label has not arrived at the sensor area 5 sec. after printing or it wasn't detected.

Applicator is not switched on.

will send the