Cisco NCS 6008 Manuel - Sayfa 6

Ağ Yönlendiricisi Cisco NCS 6008 için çevrimiçi göz atın veya pdf Manuel indirin. Cisco NCS 6008 12 sayfaları. 6000 series network convergence system routers unpacking, moving, and securing guide
Ayrıca Cisco NCS 6008 için: Ambalajdan Çıkarma, Taşıma ve Emniyete Alma Kılavuzu (44 sayfalar)

Sayfayı Yazdır

Configure the XR VM Management Port

6. exit

7. router static address-family ipv4 unicast 0.0.0.0/0 default-gateway

8. commit

DETAILED STEPS

Step 1

configure

Step 2

interface MgmtEth rack/slot/CPU0/port

Example:

RP/0/RP0/CPU0:router(config)#interface mgmtEth 0/RP0/CPU0/0

Enters interface configuration mode for the management interface of the primary RP.

Step 3

ipv4 address ipv4-address subnet-mask

Example:

RP/0/RP0/CPU0:router(config-if)#ipv4 address 10.1.1.1 255.0.0.0

Assigns an IP address and a subnet mask to the interface.

Step 4

ipv4 address ipv4 virtual address subnet-mask

Example:

RP/0/RP0/CPU0:router(config-if)#ipv4 address 1.70.31.160 255.255.0.0

Assigns a virtual IP address and a subnet mask to the interface.

Step 5

no shutdown

Example:

RP/0/RP0/CPU0:router(config-if)#no shutdown

Places the interface in an "up" state.

Step 6

exit

Example:

RP/0/RP0/CPU0:router(config-if)#exit

Exits the Management interface configuration mode.

Step 7

router static address-family ipv4 unicast 0.0.0.0/0 default-gateway

Example:

RP/0/RP0/CPU0:router(config)#router static address-family ipv4 unicast 0.0.0.0/0 12.25.0.1

Specifies the IP address of the default-gateway to configure a static route; this is to be used for communications with

devices on other networks.

Step 8

commit

Bring-up the Cisco NCS 6008 Router