Cisco 1700 series Donanım Sorun Giderme - Sayfa 5

Kablosuz Erişim Noktası Cisco 1700 series için çevrimiçi göz atın veya pdf Donanım Sorun Giderme indirin. Cisco 1700 series 12 sayfaları. Secure firewall management center
Ayrıca Cisco 1700 series için: Mevzuata Uygunluk ve Güvenlik Bilgileri Kılavuzu (45 sayfalar), Manuel (15 sayfalar), Yapılandırma Kılavuzu (25 sayfalar), Uygulama Notu (41 sayfalar), Genel Bakış Kılavuzu (13 sayfalar), Yapılandırma (34 sayfalar), Manuel (5 sayfalar), Hızlı Başlangıç Kılavuzu (6 sayfalar), Donanım Kurulum Kılavuzu (46 sayfalar)

Sayfayı Yazdır

Cisco - Hardware Troubleshooting for Cisco 1700 Series Routers

If you have the output of a show command from your Cisco device (including show technical-

support), you can use the

fixes. To use the

Output Interpreter

enabled.

Troubleshooting ISDN Interfaces

Here is a list of references to use for troubleshooting ISDN interfaces:

Troubleshooting ISDN Layer 1

Troubleshooting ISDN Layer 2

Troubleshooting ISDN Layer 3

Troubleshooting Router Hangs

Refer to

Troubleshooting Router Hangs

Troubleshooting Bus Error Crashes

The system encounters a bus error when the processor tries to access a memory location that either does

not exist (a software error) or does not respond properly (a hardware problem). A bus error can be

identified by looking at the output of the show version command provided by the router (if not power-

cycled or manually reloaded).

Here are two examples of bus error crashes:

Router uptime is 2 days, 21 hours, 30 minutes

System restarted by bus error at PC 0x30EE546, address 0xBB4C4

System image file is "flash:igs-j-l.111-24.bin", booted via flash

.........

At the console prompt, the following error message might also be seen during a bus error:

*** System received a Bus Error exception ***

signal= 0xa, code= 0x8, context= 0x608c3a50

PC = 0x60368518, Cause = 0x20, Status Reg = 0x34008002

For more information regarding this issue, refer to

Router Does Not Boot

Capturing information from the console of the router is essential for troubleshooting a router that does

not boot. The console output should be logged in a file for later analysis or for the Cisco Technical

Assistance Center (TAC) if a TAC case is opened.

The following table lists symptoms and recommended actions to take if you are encountering boot

problems:

http://kbase:8000/paws/servlet/ViewFile/17959/hwts_1700_17959.xml?convertPaths=1

Output Interpreter

(

registered

(

registered

customers only

for this issue.

) to display potential issues and

customers only

) , you must be logged in and have JavaScript

Troubleshooting Bus Error

Page 5 of 12

Crashes.

01/10/2004