DigitaLinx DL-2H1V1U-WP-W Hızlı Kurulum Kılavuzu - Sayfa 2
Verici DigitaLinx DL-2H1V1U-WP-W için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. DigitaLinx DL-2H1V1U-WP-W 8 sayfaları.
DL-2H1V1U-WP-W Quick Guide
The DigitaLinx DL-2H1V1U-WP-W is a 3x1 auto switching HDBaseT 2.0 transmitter that supports the
long distance transport of HDMI, VGA and High Speed USB 2.0 signals up to 100 meters / 330' using
category cabling. The DL-2H1V1U-WP-W is 4K compatible with a max resolution of 4K@60Hz / 4:2:0
8bit deep color. An additional analog audio pass through input is located on the wall plate that allows
for audio distribution to the HDBaseT receiver side. With 48V integrated PoH, the DL-2H1V1U-WP-W
can be powered via HDBaseT receiver with a PSE module or the wall plate can be powered by a local
power supply.
The DL-2H1V1U-WP-W gives you the ability to automate the display power ON by using pre-loaded
RS232 commands whenever a video signal is introduced to the system using either HDMI input. It will
also turn the display power OFF after a specified amount of time has passed when no video signal is
present. The DL-2H1V1U-WP-W also gives you the ability to turn the display ON or OFF as well and
switch from one input to another manually using the control buttons on the transmitter face plate. For
a complete list of programming commands to automate display power status, please see the complete
owners manual online at www.libav.com or by using the QR code on the print page of this guide.
The DL-2H1V1U-WP-W is ideal for situations where USB must be extended alongside HDMI for display
interactivity for items such as interactive whiteboards or projectors.
NOTE: The DL-2H1V1U-WP-W HDBaseT transmitter must be used with the DL-HD2-RX or the
DL-HD2A-RX HDBaseT 2.0 receiver (sold separately) to complete the extension circuit.
• DL-2H1V1U-WP-W HDBaseT Wall Plate Transmitter
• (1) Quick Install Guide
• (1) 2 pin Phoenix Male Connector
• (1) 2 gang Decorator style wall plate cover with screws
• (1) 2m / 6' USB A to B Cable
2