Cisco Catalyst IW6300H-AC Kurulum Kılavuzu - Sayfa 2

Kablosuz Erişim Noktası Cisco Catalyst IW6300H-AC için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco Catalyst IW6300H-AC 28 sayfaları.

Installing the Access Point

Access Point Mounting Orientation

Cisco Catalyst IW6300 Heavy Duty Series Access Points are only intended to be installed vertically with the

antenna ports facing upwards. If you want the antennas to face down, you should use the Extender Bracket

Kit (IOT-ACCPMK-LB=). Any other mounting orientation will compromise the IP66/67 and type 4X ingress

ratings required for safety and hazardous locations compliance.

The access point is oriented with the system LED pointing down and the access cover facing out. This

positioning allows the LEDs to be visible to someone on the ground below the access point, and the I/O

interfaces are on the bottom to minimize moisture ingress in case ports are not adequately sealed.

Note

Omnidirectional antennas are vertically polarized and should be mounted vertically.

The following figures show the dimension of the access point:

Figure 1: Unit Dimension - Front

Installing the Access Point