Cisco WAP131 Hızlı Başlangıç Kılavuzu - Sayfa 7

Kablosuz Erişim Noktası Cisco WAP131 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco WAP131 13 sayfaları. Reboot and reset factory default settings
Ayrıca Cisco WAP131 için: Hızlı Başlangıç Kılavuzu (13 sayfalar), Manuel (4 sayfalar), Manuel (4 sayfalar)

Sayfayı Yazdır

Follow the Setup Wizard instructions to finish the WAP device

TEP

installation. We strongly recommend that you use the Setup

Wizard for the first installation.The Setup Wizard turns on the Wi-Fi

radio, which allows you to connect wirelessly. For more advanced

configurations, see the Administration Guide.

Congratulations, you can now start using your Cisco WAP131.

Suggested Next Steps

In case of an error while installing, try the following troubleshooting

procedures described in this section:

Troubleshooting

If you cannot display the Configuration Utility, you can test the ability of the

computer to communicate with the wireless access point by using ping. To

use ping on a computer running Windows:

Verify that the Cisco WAP131is powered on and the lights indicate

TEP

the appropriate links.

Locate the Cisco WAP131's IP address. While there are different

TEP

ways to locate the Cisco WAP131's IP address, this procedure

uses Cisco FindIT.

If you have previously downloaded Cisco FindIT, open Internet

Explorer and launch Cisco FindIT. For more information on

downloading Cisco FindIT, see www.cisco.com/go/findit.

b. In the Cisco FindIT display, place your mouse over the Cisco

WAP131's name. The Cisco WAP131's IP address is displayed

along with other device information.

Open a command window by choosing Start > Run and enter

TEP

cmd.

At the command window prompt, enter ping and the Cisco

TEP

WAP131's IP address. In this example, we pinged 192.0.2.10.

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:

Reply from 192.0.2.10: bytes=32 time<1ms TTL=128

Cisco WAP131 Quick Start Guide