Cisco WAP361 Hızlı Başlangıç Kılavuzu - Sayfa 8

Kablosuz Erişim Noktası Cisco WAP361 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco WAP361 17 sayfaları. Reboot and reset to factory default settings
Ayrıca Cisco WAP361 için: Manuel (4 sayfalar)

Sayfayı Yazdır

Connecting the Cisco WAP361

You can perform the initial configuration using either a wired or wireless

connection. The default configuration of the Cisco WAP361 has the Wi-Fi

radio turned on.

To connect the Cisco WAP361 to the wired network:

Connect the Ethernet cable to the Ethernet port of a switch, a router,

TEP

or a PC.

Connect the other end of the network Ethernet cable to the

TEP

Ethernet port of the Cisco WAP361.

If PoE is not provided, plug in the supplied power adapter to

TEP

provide power to the Cisco WAP361.

This wireless default configuration will not allow traffic between WiFi and

Ethernet; users will need to go through the setup wizard to resume the

traffic between WiFi and Ethernet.

To connect the Cisco WAP361 to the network wirelessly:

Use wireless clients to locate the WAP361's SSID (CiscoSB-Setup).

TEP

Use the 'cisco123' passkey to access the access point.

TEP

The system provides a one-time-only access to configure the

OTE

access point using a wireless connection.

After installation, all lights should be active. Refer to

Hardware Installation

WAP361.

for details about the different lights on the Cisco

Verifying the

Cisco WAP361 Quick Start Guide