Cisco WAP361 Manual de início rápido - Página 8
Procurar online ou descarregar pdf Manual de início rápido para Ponto de acesso sem fios Cisco WAP361. Cisco WAP361 17 páginas. Reboot and reset to factory default settings
Também para Cisco WAP361: Manual (4 páginas)
Imprimir página
Connecting the Cisco WAP361
4
You can perform the initial configuration using either a wired or wireless
connection. The default configuration of the Cisco WAP361 has the Wi-Fi
radio turned on.
To connect the Cisco WAP361 to the wired network:
Connect the Ethernet cable to the Ethernet port of a switch, a router,
S
1
TEP
or a PC.
Connect the other end of the network Ethernet cable to the
S
2
TEP
Ethernet port of the Cisco WAP361.
If PoE is not provided, plug in the supplied power adapter to
S
3
TEP
provide power to the Cisco WAP361.
This wireless default configuration will not allow traffic between WiFi and
Ethernet; users will need to go through the setup wizard to resume the
traffic between WiFi and Ethernet.
To connect the Cisco WAP361 to the network wirelessly:
Use wireless clients to locate the WAP361's SSID (CiscoSB-Setup).
S
1
TEP
Use the 'cisco123' passkey to access the access point.
S
2
TEP
The system provides a one-time-only access to configure the
N
OTE
access point using a wireless connection.
After installation, all lights should be active. Refer to
Hardware Installation
WAP361.
8
for details about the different lights on the Cisco
Verifying the
Cisco WAP361 Quick Start Guide