Argo ASIBS9DC Kullanım Talimatları Kılavuzu - Sayfa 11

Klima Argo ASIBS9DC için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Argo ASIBS9DC 17 sayfaları.

Sayfayı Yazdır

ADDITIONAL MAINTENANCE

The inspection or replacement of internal components

involve the removal of the condensate drain pan.

CAUTION

Some metal edges and the vanes of heat exchanger are

sharp and may cause injury if handled improperly; be

especially careful when you clean these parts.

HOW TO REMOVE THE CONDENSATE DRAIN PAN

RUBBER CORK

S U P P O R T

PLATE (2)

SCREW (4)

SPECIAL SCREW (4)

1.Open the air intake grille.

2.Drain the condensate water into a bucket trough the

rubber cork that should be soon closed.

3.Remove the frame-grille assembly by loosening the four

special screws with washer; you can utilise the two clips

that fix the frame to the unit.

4.Disconnect the electrical connectors between the frame-

grille assembly and the unit.

5.Remove the four screws of the two support plates.

6.Grasp the two support plates, remove with care the

condensate drain pan and clean it inside, if necessary .

7.Once finished the maintenance, reassemble the pan,

aligning the side with the hole for condensate drain and

the side with the pump; insert the connectors of the unit

into the proper hole in the pan.

8.Fix again the four screws of the support plates and the

frame group aligning the corner from which the wires exit

and the corner with the connectors of the unit.

9.Mount the air intake grille along with the filter; be sure

that the safety string has been attached and that the latch

screw has been fixed on both sides.

TIPS FOR ENERGY SAVING

DO NOT:

DO:

TROUBLESHOOTING

CONNECTORS

CONDENSATE

DRAIN PAN

CLIPS (2)

If your air conditioner does not work properly , first check

the following points before requesting service.

If it still does not work properly, contact your dealer or service

centre.

Trouble: the air conditioner does not run at all.

Possible cause:

1. Power failure.

2. Leakage breaker tripped.

3. Operation button is OFF.

4. Batteries in remote control unit have run down.

Remedy:

1. Restore power.

2. Contact service centre.

3. Press the button again.

4. Replace batteries.

Trouble: Poor cooling or heating performance.

Possible cause:

1. Dirty or clogged air filters.

2. Heat source or many people in room.

3. Doors and/or windows are open.

4. Obstacle near air intake or air discharge port.

5. The set temperature on the remote control unit is too

6. Outdoor temperature is too low (heat pump version).

7. Defrosting system does not work (heat pump version).

Remedy:

1. Clean air filters to improve airflow.

2. Eliminate heat source if possible.

3. Shut them to keep the heat or cold out.

4. Remove it to ensure good airflow.

5. Set the right temperature on the remote control unit.

6. Try to use a back-up heater.

7. Consult your dealer.

Trouble: Clicking sound is heard from the air conditioner.

Possible cause:

1. During operation, any plastic parts may expand or shrink

Remedy:

1. This is normal, and the sound will disappear when an

Block the air intake and outlet of the unit.

If they are obstructed, the unit will not work well, and

may be damaged.

Let direct sunlight into the room. Use sunshades,

blind or curtain.

Always try to keep the air filter clean. A clogged filter

will impair the performance of the unit.

To prevent conditioned air from escaping, keep windows,

doors and any other openings closed.

WARNING

The use of portable telephones near the air conditioner

may cause disturbance to its normal operation and must

be avoided. In case abnormal operation is noticed,

(OPERATION lamp lights, but the air conditioner will not

run) to restore normal operation turn-off electric supply

for about 3 minutes, by disconnecting the main switch or

the wall plug, then start again the air conditioner.

high.

due to a sudden temperature change. In this event, a

clicking sound may occur.

even temperature is settled.