Cisco MXP Series Fiziksel Arayüz Kılavuzu - Sayfa 13
Konferans Sistemi Cisco MXP Series için çevrimiçi göz atın veya pdf Fiziksel Arayüz Kılavuzu indirin. Cisco MXP Series 28 sayfaları.
Sayfayı Yazdır
MXP Series Codecs
Contents
Network Interface Sockets
TIP!
Wherever applicable, the use of Category 5
cabling or better is strongly recommended! For
HD camera applications, however, Category 7.5 is
required.
TIP!
If you connect your Codec directly to a PC,
make sure you set up the system to use static TCP/
IP settings. There will be no DHCP server controlling
the little LAN created by the computer and the
Codec. When configuring a back-to-back connection
between the PC and the Codec, make sure both static
IP addresses exist on the same subnet.
E1/T1 Interface
PRI
Pin-Out
Crossover
PRI cable
Pin 1
RX+
4
Pin 2
RX–
5
Pin 4
TX+
1
Pin 5
TX–
2
D14790.01 MXP Series Codec Physical Interface Guide, May 2011.
© 2011 Cisco Systems, Inc. All rights reserved.
Introduction
ISDN BRI interface.
ISDN I.420 (RJ-45 Jack) Basic
Rate Interface S/T (2B + D),
128 kbps per ISDN I/F.
Use any standard ISDN BRI cable
to connect the Codec to BRI.
S/T Interface
BRI
Pin-Out
Pin 3
TX+
Pin 4
RX+
Pin 5
RX–
Pin 6
TX–
Codec 6000 MXP
Codec 6000 MXP
ISDN PRI (E1/T1) interface.
•
1 × PRI (RJ-45 Jack) Primary Rate & Leased
Line E1/T1 (G.703) Interface up to 2 Mbps.
•
1 × PRI (RJ-45 Jack) Primary Rate (for future
use). Use any standard PRI cable to connect
the Codec to PRI.
Ethernet LAN (RJ-45 Jack) interface
(10/100 Mb). Up to 4 or 6 Mbps, depending
on the bandwidth option installed. Use any
standard Ethernet cable to connect the Codec
to a LAN.
If no LAN is available and the Codec is
connected directly to a computer, use a
crossover cable.
Ethernet cable
Wiring diagram of
a standard cable
1
-------
1
2
-------
2
3
-------
3
6
-------
6
13
Physical interface guide
Codec 3000 MXP
Ethernet cable
RJ-45 Connector
pin-out
Wiring diagram of
a crossover cable
1
1
TOP
2
2
3
3
FRONT
6
6
Contact us
1
8
1
8
www.cisco.com