Sony BRC-300 Teknik Özellikler - Sayfa 2

Video Kamera Sony BRC-300 için çevrimiçi göz atın veya pdf Teknik Özellikler indirin. Sony BRC-300 8 sayfaları. 3ccd color video camera
Ayrıca Sony BRC-300 için: Broşür ve Teknik Özellikler (8 sayfalar), Broşür ve Teknik Özellikler (8 sayfalar), Teknik Özellikler (8 sayfalar), Broşür (8 sayfalar), Broşür (8 sayfalar), Broşür ve Teknik Özellikler (8 sayfalar), Komut Listesi (23 sayfalar)

Sayfayı Yazdır
Sony BRC-300 Teknik Özellikler
CRESTRON HARDWARE REQUIRED:
SETUP OF CRESTRON HARDWARE:
VENDOR FIRMWARE:
VENDOR SETUP:

CABLE DIAGRAM:

current speed will be displayed on the 2-digit display on a scale of 00- 99.
3.
Rotate the wheel on the side of the C2N-CAMIDJ to the desired speed. The
speed will be automatically saved.
4.
Continue selecting and setting speeds until High and Low speeds have
been set for Pan, Tilt, and Zoom. Focus speed cannot be set.
The normal use of the side wheel on the C2N-CAMI-DJ is for Focus Adjustments.
When Fo is displayed, the wheel will control focus. When Ir is displayed, Iris is being
controlled. When a number is displayed, a speed is being adjusted. Note that the
wheel will only control focus if the camera has been put into Manual Focus mode.
Some picture adjustments and white balance controls are only valid when the
camera is in certain modes. Please see the demo program for an example of how to
structure sub pages and button options for these functions.
CNX Internal com ports, C2 Internal com ports, ST-COM, CNXCOM-2, C2COM-2,
C2COM-3
RS232
Baud: 9600
Parity: N
Data Bits: 8
Stop Bits: 1
None
If you are using more than one camera with the VISCA inputs daisy chained, you
must pulse the Set_Addresses input. This will set the address of each camera on the
daisy chain. You should only pulse the Set_Addresses input on one of the modules in
the program, not on all of them.
CNSP-504