Argo CULT Kullanım Talimatları - Sayfa 3

Isıtıcı Argo CULT için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Argo CULT 5 sayfaları. Ceramic fan heater

WARNING: AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING.

The symbol below signals the above warning:

• The fan heater may cause the risk of fire if, while in operation, is covered by or comes into contact with inflammable

material including curtains, drapery, blankets, etc. KEEP THE FAN HEATER AWAY FROM THESE MATERIALS.

• Do not connect the appliance to the mains power before it has been properly assembled and positioned.

• Do not run the cord under carpets. Do not cover the cord with blankets, carpets or similar materials. Place the cord far

away from busy areas or where it cannot be accidentally pulled-out.

• Do not operate the fan heater in close proximity to bathtubs, showers, washbasins or pools.

• Do not position the fan heater below a socket outlet.

• Do not operate the appliance outdoors.

Upon initial start-up, the fan heater may emit a slight, harmless smell. This smell is a normal effect of the initial heating

up of the internal heating elements, and should not recur later on.

WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING

POWER. WHEN SERVICING OR MOVING THE FAN HEATER, ALWAYS UNPLUG THE POWER CORD.

• A fan heater has hot and arcing or sparkling parts inside. It must not be used in potentially dangerous locations such as

flammable, explosive, chemical-laden or wet atmosphere.

• Do not place the fan heater on soft surfaces, like a bed, where openings may become blocked. Always place the fan

heater on a stable, flat, level surface when operating, to avoid the chance of the fan heater overturning. Locate the power

cord so the fan heater or other objects are not resting on it.

• Always unplug the fan heater when not in use.

• In order to avoid accidents turn unit off if unattended.

• In the event of any problems (abnormal noise or a strange smell) switch off the appliance immediately, do not

attempt to repair it and take it to your local after sales service.

•

Thermostat knob

On/off and selection knob

Air outlet grille

4. Base of the appliance

Put the fan heater vertically on a flat and stable surface. Use the handle when you move the appliance.

Connect the power cord to a suitable electric socket (220-240V~/50Hz).

Turn the thermostat knob clockwise to maximum position "+".

Turn on the On/off and selection knob and select one of the possible positions: Cold ventilation, ECO mode (1100W), ECO

mode + oscillation, COMFORT mode (1800 W), COMFORT mode + oscillation.

V 05/15

DESCRIPTION OF PARTS

HOW TO USE THE FAN HEATER

5. Tip over switch

6. Intake grille with filter that can be removed for cleaning

7. Carrying Handle