Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 12

Ağ Donanımı Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Kurulum Notu (46 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Manuel (19 sayfalar), Kurulum Notu (36 sayfalar)

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu
Installing the CSM
Figure 2
Insert module
between slot guides
Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the
Step 6
following sets of substeps:
Horizontal slots
Position the supervisor engine or module in the slot. Make sure that you align the sides of the module
a.
carrier with the slot guides on each side of the slot. (See
Carefully slide the supervisor engine or module into the slot until the EMI gasket along the top edge
b.
of the module makes contact with the module in the slot above it and both ejector levers have closed
to approximately 45 degrees with respect to the module faceplate. (See
Catalyst 6500 Series Switch Content Switching Module Installation Note
12
Positioning the Module in a Horizontal Slot Chassis
EMI gasket
3
4
4
5
5
6
6
WS-X6K-SUP2-2 GE
1
CONSOLE
CONSOLE
SUPERVISOR2
WS-X6K-SUP2-2 GE
2
CONSOLE
CONSOLE
SUPERVISOR2
3
4
5
6
WS-X6224
24 PORT 100FX
EMI gasket
o
WS-C 6500- SFM
SWIT CH FABR IC MDL
Ejector lever fully
extended
Switch
Load
100%
PORT
PORT 1
MODE
PORT 2
PCMCIA
EJECT
1%
Switch
Load
100%
PORT
PORT 1
MODE
PORT 2
PCMCIA
EJECT
1%
o
INPUT
FAN
OUTPU T
OK
OK
FAIL
INPUT
FAN
OUTPU T
OK
OK
FAIL
Figure
2.)
Figure
3.)
78-15751-01