Argo WALLNER DWL-4CF Kullanım Kılavuzu - Sayfa 8

Laminatör Argo WALLNER DWL-4CF için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Argo WALLNER DWL-4CF 12 sayfaları. Laminating machine

Sayfayı Yazdır
OPERATION INSTRUCTION

HOT LAMINATION

1.
Before laminating it is advisable to carry out a test lamination to familiarise yourself
with the machine and to make sure that it is working correctly.
2.
Plug the machine into an appropriate and easy-to-reach socket.
3.
Choose the appropriate pouch's thickness to the laminated material and adjust the
temperature accordingly to the used pouch's thickness by using the temperature
regulator (3). It is a preliminary setting.
4.
Set the main switch (4) placed on the side of the laminating machine in the „I" position.
The POWER light (1) will lighten up.
5.
The laminating machine warms-up for about 4-6 minutes.
6.
The machine is ready to use when the READY light (2) lightens up.
7.
Insert the document with the sealed side first into the entry (5).
8.
The laminating process is finished when the whole document comes out from the
other end of the machine.
9.
If the document is not properly laminated, repeat steps 7 and 8 again.
10.
If the pouch gets jammed inside, push the RELEASE/REVERSE (6), then the pouch
can be easily pulled out of the entrance.
11.
If you are not using the machine, turn it off. This will guarantee best laminating results
each time.
CAUSION!
Documents need to be inserted into the laminating pouch squarely and centrally, with
a margin of around 3 mm from each side. A wider margin may cause folding, bending
or blocking of the laminated document.

COLD LAMINATION

1.
Set the main switch (4) placed on the side of the laminating machine in the „I" posi-
tion. The POWER light (1) will lighten up.
2.
Set the temperature regulator (3) in the „COLD" position. The READY light (2) will
lighten up.
3.
Insert the document with the sealed side first into the entry (5).
4.
Take out the laminated document
HOW TO TURN OFF THE LAMINATING MACHINE
1.
Set the temperature regulator (3) in the „COLD" position.
2.
Wait 10 minutes.
3.
Turn the main switch (4) placed on the side of the machine to position „O".
4.
Unplug the machine from the socket. The machine is turned off now.
© ARGO S.A.
EN
8
www.argo.pl