Argo WALLNER DWL-4CF Kullanım Kılavuzu - Sayfa 9

Laminatör Argo WALLNER DWL-4CF için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Argo WALLNER DWL-4CF 12 sayfaları. Laminating machine

CLEANING THE ROLLERS

Before and after the lamination use a cleaning paper to clean the rollers from dust and
glue. When the temperature is rising, place the cleaning paper and make it go through
the laminating machine a few times. It will protect the machines from laminating pouches
being pulled between the rollers. The cleaning paper may be replaced with a cardboard
of the grammature around 250 g/m² with a rough texture.
CLEANING THE COVER
1. When the cover is dirty, use a soft wet cloth to clean it.
2. Do not use solvents or petrol.
3. Do not unscrew the cover to clean the rollers! It may cause electric shock!
HOW TO OBTAIN THE BEST RESULTS
1.
If your laminating pouch is not envelope-type it may be pulled in during the lamina-
tion. The use of laminating pouches other than recommended may cause trouble
during lamination.
2.
Lines or wrinkles may appear, if the laminating pouch is not placed straight.
3.
If the margin of the laminating pouch is wider then 3mm, pouches may fold on both
edges of the document.
4.
Laminated edges may not hold if the document is thicker than 300 mic.
5.
The lamination of documents of the thickness lower than 150 mic or the use of
lami¬nating pouches of the thickness lower than 80 mic, especially cheap pouches
where the PET layer is thicker than 50 mic, may cause wrinkles. In such cases it is
advised to use a relatively low temperature (around 90ºC) or to use a carrier.
6.
If the laminated pouch is misty or does not show good gluing qualities, then you need
to use a higher temperature.
7.
If the laminated pouch is curved or wrinkled on the side, then you need to use a
lower temperature
8.
Too high temperature may cause the pulling of the document into the rollers - use
the RELEASE/REVERSE button to release the document and clean the rollers from
the glue.

TECHNICAL DATA

Model
Voltage
Max laminating width
Max laminating thickness
Max. thickness of the document
Warm - up time
Lamination speed
© ARGO S.A.
EN
DWL-4CF
220V 50Hz
do 240 mm
150 mic
0,6 mm
4-6 min
350 mm/min
9
DWL-3AF
220V 50Hz
do 340 mm
150 mic
0,6 mm
3-5 min
350 mm/min
www.argo.pl