Cisco ASA 5585-X Bakım Kılavuzu - Sayfa 17

Ağ Donanımı Cisco ASA 5585-X için çevrimiçi göz atın veya pdf Bakım Kılavuzu indirin. Cisco ASA 5585-X 44 sayfaları. Maintenance and upgrade procedures
Ayrıca Cisco ASA 5585-X için: Hızlı Başlangıç Kılavuzu (40 sayfalar), Hızlı Başlangıç Kılavuzu (6 sayfalar)

Sayfayı Yazdır
Cisco ASA 5585-X Bakım Kılavuzu
Chapter 4
Maintenance and Upgrade Procedures
Table 4-4
Table 4-4
Figure
Label
1
2
3
4
5
1. The power-supply module has three output voltages—3.35 V, 12.5 V, and 50 V.

Installing the DC Power Supply Module

The DC power-supply module has a 1150-W output with three DC voltage outputs of 50 V, 12.25 V, and
3.35 V. The module operates between -40.5 to -72 VDC. The power-supply module shares current on the
50V and 12.25 V outputs, and can only be used in a dual (redundant) hot-pluggable configuration. The
DC power-supply module operates from a single 40 A DC input circuit with at full output load of 1150
W, -40.5 VDC input, and does not exceed 33 A.
To install a DC power-supply module in the ASA 5585-X, follow these steps:
Step 1
Remove existing modules from the appliance:
a.
b.
OL-22567-02
describes the DC power-supply module indicators and power-switch position labels.
DC Power Supply Module Indicators
Indicator
Description
IN OK
Status of power-supply module:
•
Unlit—No DC power cables connected, or DC power switch is off.
•
Green—DC power cables connected and DC power switch is on.
FAN OK
Indicates status of fan module
Unlit—Fan module failure, or DC power switch is off.
•
Green—DC power cables connected, DC power switch is on, and internal
•
fan is running.
OUT FAIL
Red—Output voltage failure
•
ON
When this side of power switch is depressed, power is on.
•
STANDBY
•
When this side of power switch is depressed, device is in stand-by mode.
If you are replacing AC power with DC power, remove both modules from the appliance (fan module
and power supply module, or both power supply modules) as shown in Step 1 through Step 4 in
Removing and Installing an AC Power Supply Module, page
If you are replacing a failed DC power-supply module with a new DC power-supply module, follow
the steps in
Removing the DC Power Supply Module, page
1
Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide
Removing and Installing the Power Supply Module
4-13. Continue with Step 2.
4-24, and then continue with Step 2.
4-17