Cisco ASA 5585-X Bakım Kılavuzu - Sayfa 19

Ağ Donanımı Cisco ASA 5585-X için çevrimiçi göz atın veya pdf Bakım Kılavuzu indirin. Cisco ASA 5585-X 44 sayfaları. Maintenance and upgrade procedures
Ayrıca Cisco ASA 5585-X için: Hızlı Başlangıç Kılavuzu (40 sayfalar), Hızlı Başlangıç Kılavuzu (6 sayfalar)

Sayfayı Yazdır

Chapter 4

Maintenance and Upgrade Procedures

Connecting DC Power to the ASA 5585-X

This section describes how to connect DC power to the Cisco ASA 5585-X, and contains the

following topics:

•

Prerequisites

Before you connect the power supply module to a power source, be sure the chassis is properly grounded.

Caution

Use the following tools and parts to connect the DC power-supply module:

•

Table 4-5

Lug

Source DC cable lugs

Source DC ground cable lugs

Before performing any of the following procedures, ensure that power is removed from the DC circuit.

Warning

Statement 1003.

OL-22567-02

Prerequisites, page 4-19

Connecting the DC Power Supply, page 4-20

5/16-inch nut-driver

M4 nut-driver

Source DC cable lugs with the following requirements:

–

Two holes with 0.62±0.02-inch spacing between the hole centers to accommodate the

power-supply terminal posts.

A 90-degree bend in the barrel to allow the source DC cables to exit the terminal block.

–

Source DC ground wire lugs with the following requirements:

•

A single hole that can accommodate the 4-mm ground post.

•

Either a straight or bent barrel.

The source DC cable and the terminal block lugs should be sized according to local and

Note

national installation requirements and electrical codes. Use only copper wire. We

recommend FCI Burndy type YA4CL-2TC10-90 and Panduit type LCD10-10AF-L

dual-hole 90 degree lugs, or the equivalent.

These parts and tools are not supplied as part of the chassis accessory kit or the DC

Note

power-supply module kit. You must purchase them separately.

shows the source DC cable and ground cable-lug tightening torque ratings.

Lug Torque Ratings

Maximum Torque

4.07Nm

2.5Nm

Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide

Removing and Installing the Power Supply Module

Recommended Torque

2.5Nm

2Nm

4-19