Cisco ASA 5585-X Bakım Kılavuzu - Sayfa 21

Ağ Donanımı Cisco ASA 5585-X için çevrimiçi göz atın veya pdf Bakım Kılavuzu indirin. Cisco ASA 5585-X 44 sayfaları. Maintenance and upgrade procedures
Ayrıca Cisco ASA 5585-X için: Hızlı Başlangıç Kılavuzu (40 sayfalar), Hızlı Başlangıç Kılavuzu (6 sayfalar)

Sayfayı Yazdır

Chapter 4

Maintenance and Upgrade Procedures

Step 3

Remove the terminal block cover by simultaneously squeezing the left and right sides of the terminal

block, and at the same time pulling the cover off the terminal block; set the cover aside

Figure 4-17

Terminal block cover

Terminal block cover clip

Using a 5/16-inch nut-driver, loosen and remove the four nut and lock-washer pairs on the terminal

Step 4

block posts. Set the nuts and lock-washers aside.

Using an M4 nut-driver, loosen and remove the nut and lock-washer from the power supply

Step 5

ground terminal.

Attach the source DC power cable lugs to the source DC cables.

Step 6

Attach the source DC ground wire lug to the source DC ground wire.

Step 7

Connect the source DC cables to the terminal block in this order

Step 8

Position the ground cable lug on the power supply ground terminal post. Slide the lock-washer over

•

the ground post and tighten the nut to secure the source DC ground wire. Do not over-tighten the nut

(see

Position the negative (–) source DC cable lug on the power-supply negative (–) terminal posts. Slide

•

the lock-washers over the terminal posts and tighten the nuts to secure the source lug to the posts.

Do not over-tighten the nuts (see

•

Position the positive (+) source DC cable lug on the power supply positive (+) terminal posts. Slide

the lock-washers over the terminal posts and tighten the nuts to secure the source lug to the posts.

Do not over-tighten the nuts (see

OL-22567-02

Removing the Terminal Block Cover

Table

4-5).

Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide

Removing and Installing the Power Supply Module

(Figure 4-18 on page

Table

4-5).

Table

4-5).

(Figure

Terminal block

4-22):

4-17).

4-21