Cisco Catalyst 3030 Başlangıç Kılavuzu - Sayfa 16

Ağ Donanımı Cisco Catalyst 3030 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco Catalyst 3030 34 sayfaları. Cisco systems catalyst blade switch getting started guide

Sayfayı Yazdır

Managing the Switch

Step 10

Step 11

Managing the Switch

Using the CLI

Cisco Catalyst Blade Switch 3030 Getting Started Guide

1-16

interface GigabitEthernet0/16

end

These choices appear:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the

switch reboots, save it in NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

Disconnect the server chassis serial port or the switch console port from the PC.

See the

"Managing the Switch" section on page 1-16

configuring and managing the switch.

If you need to rerun the initial configuration dialog, see the

Configuration" section on page

After completing the initial setup and configuration steps, use the CLI, the device

manager, or other management options described in this section for further

configuration.

After setting up and installing the switch in your network, you can enter Cisco

IOS commands and parameters through the CLI. Access the CLI either by

connecting your PC directly to the switch console port or through a Telnet session

from a remote PC or workstation. You can also access the CLI through the server

chassis console serial port (see

page

1-9).

Cisco Catalyst Blade Switch 3030 Getting Started Guide

1-22.

"Configuring the Switch Module" section on

for information about

"Resetting the Switch

78-17052-01