Cisco Catalyst 3030 Руководство по началу работы - Страница 16

Просмотреть онлайн или скачать pdf Руководство по началу работы для Сетевое оборудование Cisco Catalyst 3030. Cisco Catalyst 3030 34 страницы. Cisco systems catalyst blade switch getting started guide

Cisco Catalyst 3030 Руководство по началу работы

Managing the Switch

Step 10
Step 11
Managing the Switch

Using the CLI

Cisco Catalyst Blade Switch 3030 Getting Started Guide
1-16
interface GigabitEthernet0/16
!
end
These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the
switch reboots, save it in NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
Disconnect the server chassis serial port or the switch console port from the PC.
See the
"Managing the Switch" section on page 1-16
configuring and managing the switch.
If you need to rerun the initial configuration dialog, see the
Configuration" section on page
After completing the initial setup and configuration steps, use the CLI, the device
manager, or other management options described in this section for further
configuration.
After setting up and installing the switch in your network, you can enter Cisco
IOS commands and parameters through the CLI. Access the CLI either by
connecting your PC directly to the switch console port or through a Telnet session
from a remote PC or workstation. You can also access the CLI through the server
chassis console serial port (see
page
1-9).
Cisco Catalyst Blade Switch 3030 Getting Started Guide
1-22.
"Configuring the Switch Module" section on
for information about
"Resetting the Switch
78-17052-01