Cisco CE 2000 Platform SCE 2000 4xGBE Hızlı Başlangıç Kılavuzu - Sayfa 16

Ağ Donanımı Cisco CE 2000 Platform SCE 2000 4xGBE için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco CE 2000 Platform SCE 2000 4xGBE 29 sayfaları. Service control engine

Sayfayı Yazdır

Connecting the Management Interface

Figure 15

Cabling the Management Port

MN G 1

MN G 2

CO NS OL

LIN K/

10/1 00/

ACT IVE

LIN K/

100 0

10/1 00/

ACT IVE

100 0

By default, the management port is configured to auto-negotiation enabled.

Note

The SCE 2000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port.

Plug the Ethernet cable provided (with attached RJ-45 connector) into the Mng 1 port on the front panel of the

Step 1

SCE 2000.

Connect the other end of the Ethernet cable into your management network. The Link LED on the SCE 2000

Step 2

management port lights.

Test connectivity. From the host that you intend to use for remote management, ping to the SCE 2000 by typing ping

Step 3

and the SCE 2000 IP address, and pressing Enter.

This verifies that an active connection exists between the specified station and the management port.

PW R A

PW R B

STA TU S

BY PAS S

C is co S

AU X

LIN K RX

4 xG B E

LIN K RX

GB E-1

SU B

LIN E

NE T

GB E-2

SU B LIN

E/C AS CA

DE NE T

C E 2 0 0 0

Se rie s

LIN K RX