Cisco Prisma EtherLinX Kurulum Talimatları Kılavuzu - Sayfa 26

Ağ Donanımı Cisco Prisma EtherLinX için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Cisco Prisma EtherLinX 38 sayfaları.

SNMP Management,

Assigning Trap Destinations

Traps are sent by the manageable device to a management PC when a certain event

takes place. Follow these steps to enter a trap destination.

From the Main Configuration screen, press T.

Result: You will be asked, Enter a New IP Address.

Type the IP address of the destination device and press Enter.

Type the name of the community string (that the destination device has been

configured to accept) and press Enter.

This function enables ALL of the traps the device is capable of. If you want to be

able to selectively activate and de-activate traps, use iConfig to configure your

device.

Supported traps include: Link Down, Link Up, Cold Start, Warm Start, and

Authentication Failure.

When deployed in pairs, the Prisma FiberLinX module also supports the following

traps: Remote Unit Lost, Remote Unit Back Online, Far End TX Link On, and Far End

TX Link Off.

Removing Trap Destinations

Follow these steps to remove all trap destinations.

From the Main Configuration screen, press K.

Press Y to continue when asked if you really want to remove all trap

destinations

Press N to abort.

Press Enter.

Password Protection

Passwords are a way to make the management of the devices secure. It is the

responsibility of the network administrator to store and maintain the password lists.

If the password(s) are lost, neither the end user nor we have a way to "decode" it.

Please refer to the iConfig or HUBCTRL32 Help files, depending on whether the

product is current or legacy. Use iConfig to access the back-up copy of the PROM,

then reburn the flash PROM.

Continued

Continued on next page

4008226 Rev B