Cisco Prisma EtherLinX Manual de instrucciones de instalación - Página 26
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Hardware de red Cisco Prisma EtherLinX. Cisco Prisma EtherLinX 38 páginas.
Imprimir página
SNMP Management,
Assigning Trap Destinations
Traps are sent by the manageable device to a management PC when a certain event
takes place. Follow these steps to enter a trap destination.
1.
From the Main Configuration screen, press T.
Result: You will be asked, Enter a New IP Address.
2.
Type the IP address of the destination device and press Enter.
3.
Type the name of the community string (that the destination device has been
configured to accept) and press Enter.
This function enables ALL of the traps the device is capable of. If you want to be
able to selectively activate and de-activate traps, use iConfig to configure your
device.
Supported traps include: Link Down, Link Up, Cold Start, Warm Start, and
Authentication Failure.
When deployed in pairs, the Prisma FiberLinX module also supports the following
traps: Remote Unit Lost, Remote Unit Back Online, Far End TX Link On, and Far End
TX Link Off.
Removing Trap Destinations
Follow these steps to remove all trap destinations.
1.
From the Main Configuration screen, press K.
2.
Press Y to continue when asked if you really want to remove all trap
destinations
OR
Press N to abort.
3.
Press Enter.
Password Protection
Passwords are a way to make the management of the devices secure. It is the
responsibility of the network administrator to store and maintain the password lists.
If the password(s) are lost, neither the end user nor we have a way to "decode" it.
Please refer to the iConfig or HUBCTRL32 Help files, depending on whether the
product is current or legacy. Use iConfig to access the back-up copy of the PROM,
then reburn the flash PROM.
26
Continued
Continued on next page
4008226 Rev B