Cisco 700 series Genel Bakış - Sayfa 8

Sunucu Cisco 700 series için çevrimiçi göz atın veya pdf Genel Bakış indirin. Cisco 700 series 19 sayfaları. Using profiles
Ayrıca Cisco 700 series için: Hızlı Başlangıç Kılavuzu (8 sayfalar), Başlangıç Kılavuzu (27 sayfalar), Kullanıcı Kılavuzu (9 sayfalar), Yönetim Kılavuzu (36 sayfalar)

Product Features

IPX Support

To improve performance, only the services deﬁned in Novell IPX Router Speciﬁcation

107–000029–001 are supported, and a maximum of 400 IPX route entries and 200 IPX

SAPs are allowed. If you need more route and SAPs entries, software Release 4.0(1) and

higher supports set ipx sap helper and set ipx gateway commands.

IPX Ping

The IPX ping feature allows you to determine if the speciﬁed IPX node is alive and

reachable. Cisco 700 series routers only generate Novell IPX format ping packets when

IPX ping is sourced from the router. The response by the Cisco 700 series router to a Novell

IPX ping packet is in Novell IPX format. The response by the Cisco 700 series router to

Cisco IPX ping packets is in Cisco IPX format. (If a Novell NetWare server is pinged, the

speciﬁed server must be running the IPXPING.NLM to respond to the ping. This NLM

[NetWare Loadable Module] is part of an IPX Upgrade [IPXRTR.EXE] to NetWare

servers.) The parameters are set using the ipxping address command.

Default IPX Route

Cisco 700 series routers can route IPX packets to an established default gateway if no

learned or static route can be found for the destination in the routing table. The parameters

are set using the set ipx gateway command.

IPX SAP Filtering

IPX SAP ﬁltering controls which services are added to the Cisco 700 series router Service

Advertisement Protocol (SAP) table. You can specify ﬁlters per type range or socket range.

Before a service is added to the SAP table, the service type and socket number for the

service is checked against the existing ﬁlters. If the type and socket ranges match any of the

existing ﬁlters, service is permitted or denied based on the action speciﬁed in the action

ﬁeld of the ﬁlter. Otherwise (no ﬁlter matches the incoming service), the service is blocked.

If no ﬁlter is conﬁgured, all SAPs are permitted. The parameters are set using the set ipx

ﬁlter sap command. The maximum number of SAP ﬁlters is 20.

1-8 Cisco 700 Series Router Installation Guide